Motorola Cdm1250 Programming Software Driver As Shown
Motorola Cdm1250 Programming Software Serial Number Handy

NOTE While all of these items are available from Motorola, most are standard shop equipment items, and any equivalent item capable of the same performance may be substituted for the item listed.

This is to ensure that the product has been correctly programmed or has not been subjected to damage outside the terms of the warranty.

If your area does not have a depot, please contact your Business Development Manager, Distributor, or contact Motorola Technical Support.

Motorola Cdm1250 Programming Software Serial Number Handy

When contacting Motorola Technical Support, keep the product model number and the units serial number handy.

You can determine the RF output power, frequency band, protocols, and physical packages.

The example below shows one mobile radio model number and its specific characteristics.

If the identical replacement part is not locally available, check the parts list for the proper Motorola part number.

Order parts from the nearest Motorola Communications parts center listed in Chapter 1, Introduction.

Pull the control head away from the radio assembly as shown in Figure 2-2.

Flexible Connection Figure 2-2: Flexible Connection Removal 4.

Remove the flexible connection from the socket on the control head board.

Top Cover Removal 1.

Dismantling Tool Figure 2-3: Top Cover Removal 2.6.3 Transceiver Board Removal 1.

Motorola Cdm1250 Programming Software Driver As Shown

Remove six screws (nine for LowBand) from the diecast cover using the T20 TORX driver as shown in Figure 2-4.

Take care to slide the antenna connector and power connector out of the chassis towards the front.

Handle the transceiver board per the procedure for Safe Handling of CMOS and LDMOS Devices, Section 2.3.

If removing the transceiver board, the thermal pad material under the two Final stage devices (Q1402 and Q1403) on the radio chassis has been pulled up such that the radio chassis is exposed through the thermal pad, then the defective thermal pads must be removed and replaced.

Press the dismantling tool until the snap connectors on the side of the back housing release from the control head.

Remove the speaker from the control head housing.

CDM1250, CDM1550, CDM1550 LS, and CDM1550 Control Head Disassembly 1.

Dismount the control head housing from the back housing as described for control head CDM750, Figure 2-6.

Note: DO NOT touch or contaminate the conductive pads on the under side of the keypad or the conductive contacts on the printed circuit board.

Begin with the two screws located in the middle of the chassis followed by the four outer screws.

Since the screws usually take a set, torque the screws a second time (1.9 NM) in the same order.

Align the 0 mark on the flex with the 0 mark on the chassis to the socket on the radio assembly as shown in Figure 2-2.

Table 2-1: Service Aids Motorola Part Description Application RLN4460 Portable Test Set Enables connection to audioaccessory jack.

HVN9025 Customer Programming Soft- Programs customer option and channel data.